Blower hookup app

Follow along with the video below to see how to install our site as a web app on your home screen. Note: This feature may not be available in some browsers. Search Everywhere Threads This forum This thread. Search titles only. Search Advanced search…. Everywhere Threads This forum This thread. Search Advanced…. Log in Register. Install blower app. Pool School. Support TFP. New Content Conversations Unanswered threads New media.

Forum Rules. Blower hook-up with OmniLogic. Thread starter Golferguycouple Start date May 19, Jump to latest Follow Reply. JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding. You are using an out of date browser.

It may not display this or other websites correctly. You should upgrade or use an alternative browser. Golferguycouple Member.

May 16, 13 Tampa Florida. I just read more installing the "Hookup" automation to my pool setup. Blower for Spa hooked to relay then out to Blower - not working Gold Supporter.

Silver Supporter. Bronze Supporter. Blower Guide. In the picture you posted the right middle V 20A CB is off that looks like it is wired to the blower relay.

Click to expand You check for V with a multimeter on the load side of the relay red and black wires when the blower is on? Golferguycouple said:. No it is not It is getting V to the relay - and the blower is "on" as a Omnilogic Feature. Switch the wires to the empty hookup to app right of it and see if you have a bad relay. Just tried that The screen says that the blower is on Are the yellow relay control wires o the top of the relay plugged into the board?

En savoir plus sur LesPompeurs

Enjoying blower content? See more TFP with a donation. Give Support. I'm upgrading the firmware ATM. Check if there is voltage to the control wires of the relay when the Omni says the blower is on.

I will do after firmware update is complete. Mar 2, 47, Are you sure that you have the blower connected to the relay that is assigned to the blower?

Yes certain. It is connected app 4. What does this mean? I'm trying to update the firmware and I got that error message. Nothing to the relay ajw22 said:.

No nothing from the control wires?? Something is amiss in the Omni software and it is not triggering voltage to the relay. Jimrahbe Mod Squad. TFP Expert. LifeTime Supporter. Jul 7, 34, Bedford, TX. GGC, If hookup system is like mine, any relay can be plugged into any port on the main card.

Blower hook-up with OmniLogic

As an example, this means that relay that is in the Aux 1 position could be connected to the Article source 6 port on the main board. If you have not already done so, then I suggest that you follow the coil wire on each relay and make sure it is plugged into the right location. These chips can go bad, but generally don't click to see more go bad at once, so it might be possible to find a working relay and rewire that relay to be the blower relay.

Thanks, Jim R. You must log app or safest dating sites to reply here.

Thread Status. HelloThis thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members.

TheBlowers.com is the best live XXL pump platform with cocks of all caliber

For better visibility, consider Starting A New Thread. Top Bottom Back. Welcome to TFP! For a wealth of pool care information please check out our free Pool School. If you are in need of specific help then we encourage you to Register and ask us here in the forum!